Ice dams happen when heat from your home escapes into the attic, warms the roof deck, and melts the underside of snow. The meltwater runs down to the cold eaves and refreezes, building a ridge of ice. Water then backs up under shingles and appears as ceiling stains, peeling paint, or wet insulation. The long-term fix isn’t a heat cable—it's a balanced attic system: proper insulation to keep living-area heat where it belongs, and continuous ventilation to flush out any heat that does sneak into the attic.
Step 1 — Air Seal Before You Insulate
Insulating without air sealing is like wearing a warm coat with it unzipped. Before adding batts or blown-in insulation, seal obvious bypasses: around recessed lights (use IC-rated fixtures or covers), plumbing stacks, electrical penetrations, attic hatches, and the top plates of partition walls. Use foam, caulk, and appropriate fire-rated products where required. A well-sealed lid prevents warm, humid indoor air from driving into the attic and condensing on cold surfaces.
Step 2 — Hit the Insulation Target
For most Ontario homes, aim for an effective attic level around R-50 to R-60, achieved with blown cellulose or fiberglass plus baffle protection at the eaves. Maintain clearance at soffits so insulation doesn’t block intake. In knee-wall spaces or sloped ceilings, install proper ventilation chutes and insulate the attic-side of knee walls—these short walls are classic heat-loss hot spots.
Step 3 — Ensure Continuous Ventilation
Balanced ventilation keeps the roof deck cold in winter and dry year-round. The typical goal is roughly equal intake at soffits and exhaust at the ridge (or high gable vents where ridge isn’t feasible). Clear clogged soffits, add baffles where insulation meets the roof, and avoid mixing multiple exhaust types that can short-circuit airflow. If you only have exhaust but no intake, the system can pull warm air from the house—exactly what you don’t want.
Step 4 — Manage Indoor Humidity
Even with great insulation, high indoor humidity will load your attic with moisture. Keep winter RH in a reasonable range; vent bathrooms and kitchens outside (not into the attic), and verify that dryer exhausts to the exterior with a smooth, short run. If you see frost on the underside of the roof sheathing during cold snaps, that’s a sign of moisture moving into the attic—revisit air sealing and ventilation.
Step 5 — Watch the Details at Eaves and Valleys
At the roof edges, install ice and water shield membranes according to code and manufacturer specs. These provide backup protection where dams tend to form first (eaves, valleys, and around penetrations). Replace damaged shingles and correct sagging gutters so meltwater can escape freely.
When to Call Us
If you’re already seeing leaks, stained drywall, or long ridges of ice, a quick assessment can save your ceiling and insulation. We document conditions, check for wet materials, and provide a prioritized plan: temporary mitigation (snow removal, interior protection), followed by permanent fixes (air sealing, insulation corrections, and ventilation improvements). Addressing causes—not just symptoms—prevents repeat damage next winter.
Need an attic check-up before winter? We can assess insulation, airflow, and moisture risks and give you a practical, staged plan that fits your budget.
Call DKI - Burlington